June 2014
6-15
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
GP 4, GP 5
General Procedures and Information
GP 4 Machine Firmware Version
Purpose
Use this procedure to check the firmware version of the machine.
Procedure
From the Control Panel:
1. Press the <Information> button.
2. Use the up/down arrows to scroll to Info Pages, then press the <OK> button.
3. Use the up/down arrows to scroll to Configuration then press the <OK> button to print a
configuration report.
or:
1. From Diagnostics Mode:
2. Use the up/down arrows to select <Report> then press <OK>.
3. Use the up/down arrows to select <Configuration> then press <OK>, then <OK> again
to print a configuration report.
The firmware version is listed under Device Setup/ System.
GP 5 Altitude Adjustment
Purpose
Print quality is affected by atmospheric pressure, which is determined by the height of the
machine above sea level.
Requirements
• WiFi or Network connection
Procedure
1. Determine altitude of machine placement:
2. Press the <Information> button on the Control Panel to go to Machine Status.
3. Using the up/down arrows, naviagate to: [System Setup>Machine Setup>Altitude
Adjustment]. Press the <OK> button to confirm selections.
4. Select the correct altitude value for the placement of the machine. Table 1.
5. Press <OK>.
or:
1. Open Easy Printer Manager. Select: [Machine Settings, System Altitude Adjustment].
2. Select the correct altitude value for the placement of the machine. Table 1. Press <OK>.
Table 1 Altitude Values
Altitude Value
0 - 1000 M
0 - 3,280 ft.
Normal
1000 - 2000 M
3,280 - 6,561 ft.
High 1
2000 - 3000M
6,561 - 9,842 ft.
High 2
3000 - 4000 M
9,842 - 13,123 ft.
High 3
4000 - 5000 M
13,123 - 16,404 ft.
High 4
To Next Page
Loading...
