EasyManuals Logo

Xerox WorkCentre 3025NI Service Manual

Xerox WorkCentre 3025NI
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
June 2014
4-35
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
REP 1.19
Repairs
NOTE: The top right (viewed from the rear) Tapered Plastic Screw is different than the other
plastic screws in the printer, make sure it is installed in the correct location during replacement.
7. Remove the screws (3) (Figure 4).
Figure 4 Fuser Screws (Top View)
8. Remove the Fuser Module (Figure 5):
Lift the left side of the Fuser (viewed from the top rear), then slide it to the left and remove
it.
Figure 5 Fuser Removal (Top View)
Replacement
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the PWB to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
NOTE: The top right Tapered Plastic Screw (viewed from the rear) is different than the other
plastic screws in the printer, make sure it is installed in the correct location during replacement,
refer to (Figure 4).
Install the components in the reverse of removal.
Screws

Table of Contents

Other manuals for Xerox WorkCentre 3025NI

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 3025NI and is the answer not in the manual?

Xerox WorkCentre 3025NI Specifications

General IconGeneral
BrandXerox
ModelWorkCentre 3025NI
CategoryCopier
LanguageEnglish

Related product manuals