26
Fax Job Example: Using Delayed Fax
¾ Load originals face-up into the Document Feeder or place an original
face-down on the Document Glass.
¾ Press the [Fax] key to activate Fax mode.
¾ Press the [Menu/Exit] key.
¾ Using the Navigation Keys select [Fax Features] and press [Enter].
¾ Using the Navigation Keys select [Delayed Fax] and press [Enter].
¾ Enter the destination fax number using the Numeric Keypad and press
[Enter].
¾ Enter the name or company name of the destination fax using the
Numeric Keypad. Pressing the appropriate key on the pad cycles through
each letter and the number for the key continually. Stop when the letter or
number required displays and press the right Navigation Key to move to
the next position. Continue entering letters and numbers until the full
name displays.
¾ Press [Enter].
¾ Enter the Time to Transmit and press [Enter].
The fax will be scanned, stored and then transmitted at the programmed
time.
Deleting a Delayed Fax Job
If the job is no longer required, it can be deleted from the queue.
¾ Select [Job Status] on the Control Panel.
¾ Select the job in the queue using the Navigation Keys and press [Enter].
¾ A Cancel Job request displays, press [Enter] to cancel the job.
5
quick_use.book Page 26 Thursday, March 2, 2006 9:38 AM
To Next Page
Loading...
Need help?
General
