xFusion Digital Technologies FusionServer 2288H V6 User Manual

FusionServer 2288H V6 Server
Technical White Paper
5 Hardware Description
2022-06-25
146
Identifier
Indicator
State Description
NOTE
You can control the UID indicator status by
pressing the UID button or using the iBMC.
-
PSU indicator
⚫
Off: No power is supplied.
⚫
Blinking green at 1 Hz:
− The input is normal, and the server is
standby.
− The input is overvoltage or
undervoltage.
− The PSU is in deep hibernation
mode.
⚫
Blinking green at 4 Hz: The firmware is
being upgraded online.
⚫
Steady green: The power input and
output are normal.
⚫
Steady orange: The input is normal but
there is no output.
NOTE
The possible causes of no power output are as
follows:
⚫
Power supply overtemperature protection
⚫
Power output overcurrent or short-circuit
⚫
Output overvoltage
⚫
Short-circuit protection
⚫
Device failure (excluding failure of all
devices)
5.2.2.3 Interface
Port Positions
Figure 5-118 Ports on the rear panel
1
VGA port
2
USB 3.0 port

xFusion Digital Technologies FusionServer 2288H V6 Specifications

General

Brand	xFusion Digital Technologies
Model	FusionServer 2288H V6
Category	Server
Language	English