KC705 Evaluation Board 110
UG810 (v1.8) March 20, 2018 www.xilinx.com
Appendix D: Board Setup
7. Connect the ATX power supply to the KC705 board using the ATX power supply adapter
cable as shown in Figure D-1:
a. Plug the 6-pin 2 x 3 Molex connector on the adapter cable into J49 on the KC705
board.
b. Plug the 4-pin 1 x 4 peripheral power connector from the ATX power supply into the
4-pin adapter cable connector.
8. Slide the KC705 board power switch SW12 to the ON position. The PC can now be
powered on.
To Next Page
Loading...
