Xinje DS5C Series

26
4. Operation before using servo system
4-1.Operate panel
Button
Function
STA/ESC
Press: Status switch, status return
INC
Press: Increase the value; Press
and hold: Increase the value
continuously
DEC
Press: Decrease the value; Press
and hold: Decrease the value
continuously
ENTER
Press: Shift the editing digit; Press
and hold: Enter a status, Enter
The operate panel can display the status, set parameter and run the command by switching the
basic mode.
The running status, auxiliary function, parameter setting, and monitoring are the basic modes.
The modes switch as the below diagram by pressing STATUS/ESC.
Status: bb indicates that the servo system is idle; Run indicates that the servo system is
running, and RST indicates that the servo needs to be powered on again.
STA/ESC
DEC
INC
ENTER
power