Xylem Aquavar IPC - Pump Programming and Setpoint Configuration; Pump Programming; Single-Pump Application Setup

PAGE 14
Aquavar IPC Start-Up Genie
Xylem
Select either Single Pump or Multi-Pump
Control. Follow the programming for single
pump application below.
For Multi-Pump Programming, continue to
page 16.
Select Constant Pressure for Application type
Select PSI for pressure control units
Operating Mode
CHANGING OPERATING
MODE WILL OVERWRITE
CURRENT SETUP!
Single Pump Control
CHANGING OPERATING
MODE WILL OVERWRITE
CURRENT SETUP!
Operating Mode
Multipump Control
Application Type
Constant Pressure
Pressure control units
psi
6. PUMP PROGRAMMING
6.1 SINGLE-PUMP PROGRAMMING