Need help?Do you have a question about the Xylem hydrovar hv 1.1 and is the answer not in the manual?
General| Brand | Xylem |
|---|---|
| Model | hydrovar hv 1.1 |
| Category | Water Pump |
| Language | English |
Diagram illustrating a single pump system configuration.
Diagram illustrating a multi-pump system configuration.
Specifications and details of the PA-21 R pressure transmitter.
Specifications and details of the PD 39 M differential pressure transmitter.
Specifications for the frequency inverter and general operating data.
Physical dimensions of the HYDROVAR units and weights.
Instructions for mounting the Hydrovar unit onto the pump.
Requirements for electrical protection measures and circuit breakers.
Instructions for connecting the Hydrovar unit to the motor.
Procedure to change pressure using the front panel buttons.
Diagram illustrating the menu structure and navigation paths.
Procedure to set constant pressure for a single pump.
Configuration for protecting a single pump from over-operation.
Adjusting settings to compensate for system friction losses.
Configuration for multi-pump systems and compensation.
Settings for changing pressure and enabling automatic pump restart.
Selecting operating mode, control type, and display units.
Configuration of inverter-specific parameters.
Configuring acceleration/deceleration ramps and pressure window.
Adjusting frequency and intensity for system compensation.
Adjusting the required value increase up to maximum speed.
Setting pressure changes for multi-pump sequencing.
Configuring follow-up pump start and pump changeover intervals.
Configuring relay functions and slave pump start/stop frequencies.
Procedures for sensor zero adjustment and input range configuration.
Initiating and configuring pump test runs.
Setting test run frequency and boost voltage.
Setting operational limits and error trigger delays.
Procedures for setting passwords and restoring default configurations.
Displaying pump operating hours and configured address.
Accessing stored errors and viewing software information.
Accessing and configuring the programming device.
Procedure to change the pump's network address.
Error codes for low water and motor temperature issues.
Error codes for overvoltage, undervoltage, and overload conditions.
Error codes for heat sink, sensor faults, and conveyor limits.
Lists internal processor error codes and their meanings.
To Next Page