Xylem Aquavar IPC User Manual

Aquavar® IPC
QUICK START-UP GUIDE FOR ADVANCED IPC
QUICK START GUIDE
IM311 REV 2
FOR FULL IOM,
SCAN BELOW

Xylem Aquavar IPC Specifications

General

Relative Humidity	5% to 95% non-condensing
Control Method	PID Control
Pump Control	Level control, Pressure control, Flow control
Power Range	0.75 kW to 45 kW
Motor Power Range	0.75 kW to 45 kW
Communication Protocols	Modbus RTU, BACnet MS/TP, Profibus DP
Display	LCD
Protection Features	Overvoltage, Undervoltage, Overload, Short circuit, Phase loss, Over temperature
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +70°C

Summary

Safety and Instructions

Overview and Safety Definitions

Introduces the guide and defines safety message levels and indications.

General Safety Precautions and Personnel

Covers operator responsibilities, qualified personnel, and essential safety practices.

Critical Warnings and User Safety

Details critical warnings (discharge, leakage, unintended start) and general user safety rules.

Work Area Safety and Environmental Protection

Addresses safety equipment, work precautions, first aid, and environmental considerations.

Basic Electrical Connections

Input and Motor Wiring

3-Phase Input and Motor Output Wiring

Connects 3-phase AC input power and motor output wiring.

Single Phase Input Power Connection

Details connecting single-phase power input to the unit.

Control Wiring

Single-Pump Control Wiring

Wiring instructions for a single pump, including jumper and transducer connections.

Multi-Pump Control Wiring

Connects communication wires and configures multiple pumps for control.

Setup and Commissioning

Initial Setup and Genie Launch

Powering on the drive and launching the Start-Up Genie for configuration.

Drive Parameter Configuration

Setting regional, language, motor, and operational parameters.

Pump Programming and Setpoint Configuration

Configuring pump operation mode, application type, and setpoints.

Final Checks and Calibration Preparation

Verifying motor rotation and preparing for no flow power calibration.

Pump Programming

Single-Pump Application Setup

Configuring pump operation mode, application type, and pressure units.

Single-Pump Setpoint and Ramp Configuration

Setting ramp time and defining setpoints for single-pump operation.

Multi-Pump Control Configuration

Setting up multi-pump control, address, application type, and pressure units.

Multi-Pump Setpoint and Configuration

Configuring ramp time, number of pumps, and setpoints for multi-pump systems.

No Flow Power Calibration

No Flow Power Calibration Setup

Method to program the no flow power curve into the controller.

Sleep Mode and Flow Check Settings

Configuring sleep frequency, delay, and flow check parameters.

No Water/Loss of Prime Fault Configuration

Setting alarms and enabling no flow power calibration.

Under Pressure and System Protection Settings

Configuring under pressure, system cut-out, and pump protection settings.

VFD/Controls Technical Support