4
EN 2.10 Shuttle Manual 1712
SW 838023
Ultrasonic Level Transmitter and Sensor
A Technical specifications ...............37
Dimensions ..........................................37
Shuttle
®
Ultrasonic Sensors ..................38
Standard Range Version .......................38
Standard Range Version/FM Approved
.39
Extended Range Version ......................40
Chemical Resistant Version
..................41
B Changing supply voltage .............42
Conversion from 230 to 115 V AC ........42
Conversion from 115 to 230 V AC ........42
C Sensor mounting considerations .43
General ................................................43
Signal spread .......................................43
Measurements......................................44
Along a wall / other surface ................44
Through a concrete deck ....................44
In a tank / container ............................44
Through pipe for foam protection .......44
D Service menu ..............................45
E Special menus ............................46
Bar graph read-out ...............................47
Active measuring range ........................48
Response time .....................................49
Measuring method (application)
............50
mA output signal during system error ...51
Calibration of the level measurement
....52
Offset level readout ...............................53
Indication of echo quality ......................54
Indication of signal amplification ............55
Indication of time period without echo ..56
Select factory settings ..........................57
Access code ........................................58
Readout of version numbers .................59
Find zero level at next power-up ...........60
Fixed mA signal ....................................61
Investigative measurement intervals ......62
System alarm delay ..............................63
Averaging the level measurement .........64
Max. amplification level .........................65
Min. level for accept of ultrasonic echo .66
Sensitivity of the learning function .........67
Changing the access code ...................68
F New sensor / changing sensor .... 69
Open the choose sensor menu.............69
To Next Page
Loading...
