Xylem wtw Multi 3410 - Page 103

Operation Multi 3410
103
ba75863y18 01/2015
The sensor settings are reset under the Reset menu item in the menu
for calibration and measurement settings. To open the settings, display
the required parameter in the measured value display and press the
<MENU/ENTER> key.
ORP The following settings for ORP measurements are reset to the default
settings with the Reset function:
The sensor settings are reset under the Reset menu item in the menu
for calibration and measurement settings. To open the settings, display
the required parameter in the measured value display and press the
<MENU/ENTER> key.
Dissolved oxygen The following settings for D.O. measurements are reset to the default
settings with the Reset function:
The sensor settings are reset under the Reset menu item in the menu
for calibration and measurement settings. To open the settings, display
the required parameter in the measured value display and press the
<MENU/ENTER> key.
Conductivity The following settings for conductivity measurements are reset to the
default settings with the Reset function:
Man. temperature 25 °C
Single-point calibration off
Setting Default settings
Setting Default settings
mV resolution 0.1
Man. temperature 25 °C
Setting Default settings
Cal. interval 180d
Check interval 60 d
Measured parameter D.O. concentration
Relative slope (S
Rel
)1.00
Salinity (value) 0.0
Salinity (function) Off
Setting Default settings
Cal. interval 150 d