Multi 3410 What to do if...
110
ba75863y18 01/2015
Data transmission to
USB memory device
does not work
Data transmission to
USB printer device does
not work
Error message,
Only use rechargeable
batteries!
Ni-MH 1.2 V, >2100 mAh
CAUTION
Unsuitable batterie types can cause damage during the charging
process.
Cause Remedy
– Connected USB memory device
has not been recognized, e. g.
– the USB memory device has
been formattet to a file sys-
tem which is not supported
(e. g. NTFS)
– Use other USB memory
device
– Reformat the USB memory
device to FAT 16 or FAT 32
file system
(Caution
: Reformatting
erases all data on the USB
memory device. Back up all
data before reformatting.)
Cause Remedy
– The USB-B interface is con-
nected to a PC
– Disconnect the PC from the
USB-B interface
– Connected USB memory device
does not work
– Use a suitable USB printer
device (see section 4.12.3)
– Check printer settings (see
section 4.12.3)
– No power pack connected – Connect the power pack
Cause Remedy
– A voltage that is unusual for
NiMH rechargeable batteries
was found.
– Disconnect the power pack
from the meter.
– Check whether there are
suitable rechargeable batter-
ies (Ni-MH 1.2 V, >2100
mAh) in the battery compart-
ment.
– Unsuitable batteries:
Insert suitable recharge-
able batteries and recon-
nect the power pack.
– Suitable batteries:
Connect the power pack
and close the error mes-
sage with <[ESC]> or <M>.
To Next Page
Loading...
