27
English
Before You Begin
1
1
Set BASS, TREBLE and BALANCE on the front panel to “0” (the
center position) and turn off BASS EXTENSION.
2
2
Sit in the main listening position and set PARAMETER/SET
MENU on the remote control to PARAMETER.
3
3
Set 10KEY/DSP on the remote control to DSP and press / DTS
SUR.
4
4
Press TEST on the remote control once or twice to select the test
you want.
• Select “TEST DOLBY SUR.” to match the output levels of the Center, Rear
Center and left and right Rear speakers to the left and right Main speakers.
• Select “TEST DSP” to match the output levels of the Front Effect speakers
to the Main speakers.
Speaker Output Levels
This section explains how to set the speaker output levels using the test tone generator. The Dolby Surround test is for balancing the output
levels of the six speakers required for surround sound systems. The DSP test is for balancing the Front Effect speakers with the Main
speakers for the DSP sound field programs.
BASS TREBLE
55
44
33
22
11
0
+
–
55
44
33
22
11
0
+
–
55
44
33
22
11
0
RL
BALANCE
10KEY DSP
PARAMETER
SET MENU
To Next Page
Loading...
Need help?
General
