Yamaha NAVIGO - 12.2. Daily Checks

103
11

Buzzer sound
This function is for sounding a buzzer when the power is turned on, or when an error such as
disengaged clutches occurs.
Setting 1 ............ The buzzer sound is enabled. (Default setting)
Setting 2 ............ The buzzer does not sound when the power is turned on, the maximum speed
is adjusted, the controller is operated with the clutch levers in the manual
position, etc.
It is impossible to disable the horn and alert sounds.

LCD brightness
This function sets the brightness of the LCD of the controller.
Setting 1 ............ Normal brightness setting (Default setting)
Setting 2 ............ Slightly darker setting
Setting 3 ............ Dark setting

Electromagnetic brake operation timing selection
This function adjusts the time until the electromagnetic brake is applied after the wheelchair
stops.
Setting 1 ............ The electromagnetic brake is applied 10 seconds after the wheelchair stops.
(Default setting)
Setting 2 ............ The electromagnetic brake is applied immediately after the wheelchair stops.
(2) Driving Parameters
You can adjust settings such as speed, acceleration, and joystick sensitivity.

Preset mode
Select from 3 preset modes.
Setting 1 ............ Soft mode
Setting 2 ............ Normal mode (Default setting)
Setting 3 ............ Sports mode

Free mode
You can make ne adjustments to settings, such as speed, acceleration, joystick sensitivity, and
joystick input direction switching.
WARNING
● Whenevaluatingtheneedtochangeparametersettingsandchoosingtheactualchanges,
consulttheguidanceofexperts,suchasphysicaltherapistsandoccupationaltherapists,
and have your dealer make the changes.