104
11
11.8. Smart Tune Settings
The settings of the features and characteristics of NAVIGO can be changed to fit your usage. These
changes are performed by changing the “parameter settings” with using PC and the Smart Tune software.
Consult with your dealer on changing the parameter settings.
There are two parameter settings: “Functional Parameters” and “Driving Parameters”.
(1) Functional Parameters
Auto power o function
This is a function that turns o the power after a specied time of non-operation.
Setting 1 ............ The power turns o if the joystick has not been operated for 10 minutes. (Default
setting)
Setting 2 ............ The power turns o if the joystick has not been operated for 60 minutes.
Setting 3 ............ The power does not turn o automatically.
Buzzer sound
This function is for sounding a buzzer when the power is turned on, or when an error such as
disengaged clutches occurs.
Setting 1 ............ The buzzer sound is enabled (Default setting)
Setting 2 ............ The buzzer does not sound when the power is turned, maximum speed is
adjusted, when operated with the clutch levers in manual position, etc.
It is impossible to disable the horn and alert sounds.
LCD brightness
This function sets the brightness of the LCD of the controller.
Setting 1 ............ Normal brightness setting (Default setting)
Setting 2 ............ Slightly darker setting
Setting 3 ............ Dark setting
Electromagnetic brake operation timing selection
This function adjusts the time until the electromagnetic brake is applied after the wheelchair
stops.
Setting 1 ............ The electromagnetic brake is applied 10 seconds after the wheelchair stops.
(Default setting)
Setting 2 ............ The electromagnetic brake is applied immediately after the wheelchair stops.
To Next Page
Loading...
