Yamaha NAVIGO - Page 71

65
8
Assuming the charging process started from an empty state, the time it takes from start to
completion of the charging process is typically 2.5 to 3 hours.
If charging in a location with a high temperature or if charging a brand new battery, this may
take longer.
TIP

Check to ensure that charging is complete.
When charging is complete, the battery capacity
indicator lamps and the charge lamp (green) on
the charger turn o󰀨.
After charging is complete, you can check the
charged capacity by pressing the battery indica-
tor switch.
If not all of the lamps turn on, the following could
have occurred:
• While charging, the temperature of the battery
rose excessively, causing the protection mech-
anism to abort the charging process.
• The battery deterioration has advanced and
the capacity is decreasing.
and so on.

Unplug the power cord from the power outlet.

Remove the battery from the charger.
If you want to store the battery in this state, put
the protective cap on.
Charge lamp (green)
(all lamps turn o󰀨)
Capacity indicator
lamps
(all lamps turn o󰀨)
80 – 100%
60 – 80%
40 – 60%
20 – 40%
1 – 20%
(flashes at approx. 10%)
Indicator
switch
NOTICE
● Donotpullonthepowercord.Thiscancausethewirestobreak.
Protective cap