1
2
4
4-11
Instrument and control functions
NOTICE
Fuel tank cap
To install the fuel tank cap
1. Front wheel sensor
2. Front wheel sensor rotor
1. Rear wheel sensor
2. Rear wheel sensor rotor
1. Fuel tank cap lock cover
2. Lock.
3. Unlock.
TIP
The ABS performs a self-diagnosis
test each time the vehicle first starts
off after the key is turned to “ON”
and the vehicle has traveled at a
speed of 10 km/h (6 mi/h) or higher.
During this test, a “clicking” noise
can be heard from the front of the
vehicle, and if either brake lever is
even slightly applied, a vibration
can be felt at the lever, but these do
not indicate a malfunction.
This ABS has a test mode which
allows the owner to experience the
pulsation at the brake levers when
the ABS is operating. However,
special tools are required, so please
consult your Yamaha dealer.
Be careful not to damage the wheel
sensor or wheel sensor rotor;
otherwise, improper performance
of the ABS will result. (ABS model
only)
To remove the fuel tank cap
Open the fuel tank cap lock cover,
insert the key into the lock, and then
turn it 1/4 turn clockwise. The lock will
be released and the fuel tank cap can
be removed.
Insert the fuel tank cap into the tank
opening with the key inserted in the
lock and with the “ ” mark facing
forward.
1.
To Next Page
Loading...
