1
1
7
7-14
Periodic maintenance and adjustment
1. Coolant reservoir cover
1. Coolant reservoir cap
4. Remove the coolant reservoir cover.
Remove the coolant reservoir cap,
add coolant to the maximum level
mark, and then install the reservoir
cap. WARNING! Remove only the
coolant reservoir cap. Never
attempt to remove the radiator
cap when the engine is hot.
NOTICE: If coolant is not avail-
able, use distilled water or soft
tap water instead. Do not use
hard water or salt water since it
is harmful to the engine. If water
has been used instead of
coolant, replace it with coolant
as soon as possible, otherwise
the cooling system will not
5.
be protected against frost and
corrosion. If water has been add-
ed to the coolant, have a Yamaha
dealer check the antifreeze con-
tent of the coolant as soon as
possible, otherwise the effective-
ness of the coolant will be
reduced.
Install the coolant reservoir cover.
Place the right floorboard mat in the
original position and push it down-
ward to secure it.
Changing the coolant
The coolant must be changed at the
intervals specified in the periodic
maintenance and lubrication chart.
Have a Yamaha dealer change the
coolant. WARNING! Never attempt
to remove the radiator cap when the
engine is hot.
Recommended coolant:
YAMAHA GENUINE COOLANT
Coolant reservoir capacity (up to
the maximum level mark):
0.25 L (0.26 US qt, 0.22 Imp.qt)
6.
7.
To Next Page
Loading...
