Yanmar 6BY2 - Location of Nameplates; Engine Nameplates (Typical)

GENERAL SERVICE INFORMATION
Location of Nameplates
12/05
BY Service Manual
3-11
© 2009 Yanmar Marine International
LOCATION OF NAMEPLATES
The following figures show the location of
informational nameplates on Yanmar BY2 marine
engines.
Engine Nameplates (Typical)
The typical location of the engine nameplates is
shown for Yanmar 4BY2 Series marine engines
(Figure 3-8). 6BY2 engines are similar.
Figure 3-8Engine Data and Drive Information
Nameplates
Figure 3-8
Figure 3-9Engine Block Serial Identification
Figure 3-9
The engine block information identification is
etched into the cylinder block and is located behind
the engine oil cooler near the end of the starting
motor.
0006563
Gear Model
ENG.No.
Model
min
-1
min
-1
min
-1
Speed of prop shaft
Fuel stop power kW
Continuous power kW
/
/
0006567
4 B Y
1 0 8 5 N 0 7 5
1 1 0 0 7 8 2 4 9 5 1
N
SERIAL NUMBERS
ENGINE
TRANSOM
DRIVE
MERCRUISER
MODEL:
TRANSOM ASSEMBLY
AND STERN DRIVE
SERIAL NUMBER DECAL
STRIPS TO THE
RESPECTIVE BLANK
ON THIS DECAL.
DIVISION OF MERCURY MARINE
STILLWATER, OK, U.S.A.