Yanmar EF-494T - Page 129

4 CLUTCH 4 CLUTCH
EF494T TM 06/2011 edition
121
 Pressure plate
 Clutch disk
IMPORTANT
Pay attention to the
direction of the clutch
disc.
Pressure plate side Flywheel side
(4) Inspecting the clutch disc
 Measure the wear on the clutch face (measure
the depth of the rivet). If there is 0.5 mm or
less of clutch face remaining, replace the
clutch disc.
 If hardened material or a distorted clutch face
is seen, replace the clutch disc.
 If the clutch disc has oil on it, wash it with
gasoline.
 If the wear is seen in the splined section, or
runout is seen, replace the clutch disc.
(5) Remove the
return spring (A),
and remove the
clutch release
(bearing and
sleeve) (B).


