Yanmar EF-494T - SPECIFICATIONS; TRACTOR MASS AND TIRE SPECIFICATION

0 INTRODUCTION 0 INTRODUCTION
EF494T TM 06/2011 edition
21
0.3.7 SPECIFICATIONS
Model
EF494T
Drive type
4-wheel Drive
Dimensions
Overall length (mm)
3,230
Overall width (mm)
1,605
Overall height (mm)
2,355 (ROPS)
Wheelbase (mm)
1,830
Tread
Front (mm)
1,300, 1,466
Rear (mm)
1,270, 1,352
Ground clearance (mm)
375
Weight (kg)
1,540
Engine
Model
4TNV88
Type
4-cycle, water-cooled diesel
Output (SAE Gross) (HP/rpm)
49/2,800
Number of cylinders
4
Bore x Stroke (mm)
88 x 90
Displacement (cc)
2,189
Air cleaner
Dry, dual element
Fuel tank capacity (liter)
40
Battery
12V-52AH
Steering
Hydrostatic
Clutch
Dry, single
Brake
Mechanical, wet disc
Transmission
Type
Collar shift
Gear shift (Forward x Reverse)
F9 x R9
Forward speed (km/hr)
1.6-28.8
Reverses speed (km/hr)
1.7-29.7
Max. speed, forward (km/hr)
30.8
Tire
Front
8-18-6
Rear
13.6-26-8
Rear PTO
Type
Transmission PTO
PTO shaft
SAE1-3/8 inch (35mm), 6 spline
Speed (rpm)
568, 769 at rated engine speed
Hydraulic
Type
Position control
Hitch
3 point hitch, category SAE #1
Draw bar hitch
Clevis type
NOTE:
All technical data, measurement and weight are approximate, and the manufacturer has the right to
make alteration without prior notice.
0.3.8 TRACTOR MASS AND TIRE SPECIFICATION
TIRE SIZE
(Number of plies)
FRONT AXLE
REAR AXLE
Maximum
working load of
tires
Technically
permissible
mass on each
axle
Maximum
working load of
tires
Technically
permissible
mass on each
axle
F: 8-18(6), R: 13.6-26(8)
kg
650
980
1,580
1,675
IMPORTANT
Set up the implement so that the front wheel load and the rear wheel load are not greater than the
smaller of the following: the permissible load capacity of the tires or the technically permissible mass on
each axle.