Yanmar EF-494T - REMOVING THE FENDER; REMOVING THE STEP

2 DISASSEMBLY OF COMPONENTS 2 DISASSEMBLY OF COMPONENTS
EF494T TM 06/2011 edition
43
2.2 REMOVING THE FENDER
2.2.1 Removing the fuel tank cover
(A) Fuel tank cover
(B) Bolt M8x16, 7pieces.
Note:
Pay attention to the electrical wiring.
2.2.2 Removing the nuts and bolts that fixing
the fender
Note:
 Be careful not to lose the rubber washers (A) or
the collars (B).
 The fender can be removed without removing
the rear tire.
2.3 REMOVING THE STEP
(1) Remove the 2 screws (A), the three M6x20
bolts (B), and pull the front column cover (D).
Then, disconnect key switch coupler.
(2) Remove the four M6x20 bolts (A), and remove
the cover (B).
Note:
Be careful not to lose the rubber washers and the
collars.