<Adjustment>
Position control feedback
(1) Turn hydraulic stop valve to open fully.
(2) Start engine. Put the position control lever in
“Lowest” position and put lift arm (A) in
lowest position.
(3) Put the position control lever in “Highest”
position and listen relief valve chattering
noise. If no noise, turn position feed back
rod to raise lift arm (A) until the noise
comes.
(4) Adjust length of position feedback rod (B) so
that the free play (C) from the highest would
be 15-15mm or height of the lift arm (A) is
317 mm.
IMPORTANT
As a guide, adjust the play (C) in the lift arm (A) to
10 to 15 mm, when in the highest position.
Rod lengthened.: Lift arm lowers.
Rod shortened.: Lift arm lifts.
Note:
After each adjustment is performed, lower the lift
arm (A).
To Next Page
Loading...
