Yanmar EF-494T - GREASING

1 PERIODICAL INSPECTION 1 PERIODICAL INSPECTION
EF494T TM 06/2011 edition
33
1.13 GREASING
Before initiating day's work, check the greasing
condition at each point. Grease up after a work on a
muddy field. As a general rule, grease up various
points at intervals of 50 hours.
(A) Brake pedal shaft
(B) Clutch pedal
(C) Tie rod end
(D) Power steering rod end
(E) Center pin (front and rear)
(F) Lift link, right
NOTE:
Power steering rod ends are modified and no
greasing is required from S/N 000530.
(A)
(A), (B)
(C)
(C), (D)
(E)
(F)