..................... ............................. ..................................................................................... -A
iBi :,
I TYPE
IE 2LF It CACR-SRWl ICi
IP 1 I,.-..i
'
[ 1
• OPERATING RELAY
I SEQUENCE 3.5ram2 ,
• USER SIGNAL LARGER "
GENERATING
CIRCUIT I
I
L
P
3.5mm2
OR
LARGER
|
2mm2ORLARGER
i FRAME FRAME 3.5mm2ORLARGER/
I LRAD0F FRAMEr_ / I
i 3.5mr_ORLARGER 7_ \ /i
............................................................................ :.............._'_:Fat,ME-._ _i_ ...........................................
_ PANEL GROUNDING
]_ :Twistedpair wires _ ONEPOINTGROUNDING
Notes
]. Use wires of 3.5m_]or larger for grounding to the case (preferably flat-woven
copper wire). Fig. 6.13 Grounding Method
2. Connectlinefiltersobservingthe precautionsas shownin (2), "Noisefilter installation"
(2) Noisefilter installation I
When noise filters are installed to prevent noise from
the power line, the block type must be used. The rec-
ommended noise filters are shown in Table 6.5. The
power supply to peripherals also needs noise filters.
NOTE
If the noise filter connection is wrong, the effect (a) Separate the input and output leads. Do not bun-
decreases greatly. Observing the precautions, dle or run them in the same duct.
carefully connect them as shown in Figs. 6.14 to
6.17. _ ___
I
Table 6.5 Recommended Noise Filter
SERVOPACK Applicable Recommended Noise Filter I_
TypeCACR- Noise Filter Type Specifications BOX BOX I
I
Three-phase
SRO3BB LF-305 200VACclass,5A II i _
SRO5BB_ BOX_
Three-phase
SR07BB _ LF-310 200VAC class, 10A I_
I
SRIOBB LF-315 Three-phase
SR1 EBB CORRECT 200 VAC class, 15 A
Three-phase _ /"
SR20BB LF-320 200VAC class,20 A SEPARATECIRCUITS
Three-phase WRONG CORRECT
SR30BB LF-330 200 VAC class, 30 A
Three-phase
SR44BB _ LF-340 200VAC class,40A Fig. 6.14
WRONG t
SR6OBB LF-350 Three-phase
200 VAC class, 50 A
Note: Noisefilter made by Tokin Corp.
-44 -
To Next Page
Loading...
Need help?
General
