YASKAWA iQpump Micro

YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
iQpump Micro
Quick Start Procedure
Page 11
of 31

Install the 24 V Transducer Power Supply (continued)
5
STEP
5.11
Select one of the four ground wires packaged with the 24V Power Supply unit and attach the ground wire to the
drive.
Select the correct ground wire shown in Figure 1.5 by first removing the drive ground terminal screw as shown in
Table 1.8. Yaskawa recommends using a long Phillips screwdriver with a magnetic tip to aid in keeping the screw
captive during removal and installation.
Test fit the screw (size M3.5 to M6) into each of the four ground wire drive-side ring lugs prior to installation. Ground
wire selection varies by drive model.
With the appropriate screw removed, attach the drive-side of the ground wire to the drive ground terminal and tighten
all loosened screws.
To 24V Power Supply
Ground Screw FE
Screw Size: M3
Drive-Side Ring Lugs
To Drive Ground Terminal
Screw Size: M3.5 to M6
Figure 1.5 Ground Wire Selections
Table 1.8 Drive Ground Terminal and Screw Location
IP20/NEMA 1, UL Type 1
IP66/NEMA 4X, UL Type 4X
Models
BV0001 to BV0003
2V0001 to 2V0006
All Other Models
Drive
Ground
Terminal
Screw
Conduit Bracket
(Shown Removed
for Clarity)
Ground
Terminal
Ground Wire
Drive
Ground
Terminal
Screw
Conduit Bracket
Removed for Clarity
Ground
Terminal
Ground Wire
Drive Ground
Terminal Screw
Ground Wire
Ground Terminal
5.12
Reattach the bottom terminal cover.
Table 1.9 Reattach Bottom Terminal Cover
IP20/NEMA 1, UL Type 1 IP66/NEMA 4X, UL Type 4X
Not applicable.