YASKAWA iQpump Micro

YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
iQpump Micro
Quick Start Procedure
Page 13
of 31

Install the 24 V Transducer Power Supply (continued)
5
STEP
5.15
On models BV0006 to BV0018, 2V0010 to 2V0020, and 4V0002 to 4V0011, insert the ground wire and
J2 lead wire into the terminal cover wire notch.
Table 1.12 Insert Wires Into Routing Notch
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
Terminal Cover
Wire Routing Notch
Ground Wire and
J2 Lead Wire
To 24V
Power Supply
To Drive
After inserting the ground wire and J2 lead wire into the notch, attach the terminal cover to the 24V Power Supply.
Table 1.13 Connect Terminal Cover to 24V Power Supply
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
J
2
J2
24V Power
Supply
Terminal
Cover
5.16
Attach the 24V Power Supply or 24V Power Supply/Terminal Cover combination to the drive.
Properly seat the tabs on the left and right sides of the 24V Power Supply unit into the drive case mounting slots and
snap into place.
NOTICE: Damage to Equipment. Take proper precautions when attaching the 24V Power Supply to the drive so that no cables
are pinched between the 24V Power Supply and the drive. Failure to comply may result in damage to circuitry and equipment.
Table 1.14 Attach 24V Power Supply to Drive
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
J2
J2
J2