YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
iQpump Micro
Quick Start Procedure
Page 17
of 31
Install the 24 V Transducer Power Supply (continued)
5
STEP
5.22
Attach the 24V Power Supply cover by aligning the tabs with the mounting slots, seat the front cover into place, and
tighten the screw on the front.
Table 1.18 Attach the 24V Power Supply Cover
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
Line Up Mounting Tabs
with Mounting Slots
J2
NOTICE: Damage to Equipment. Take proper precautions when wiring the 24V Power Supply unit so that the front covers will
easily fit back onto the drive. Make sure no cables are pinched between the front covers and the drive when replacing the cover.
Failure to comply may result in damage to circuitry and equipment.
5.23
Secure the shielded cable with a customer-supplied adhesive mount wire tie positioned on the lower drive cover to
complete the installation procedure for IP20/NEMA 1, UL Type 1 enclosures.
Table 1.19 Secure the Shielded Cable
IP20/NEMA 1, UL Type 1 IP66/NEMA 4X, UL Type 4X
Customer-Supplied
Adhesive Mount Wire Tie
Slack for Strain Relief
Not applicable.
To Next Page
Loading...
