B Parameter Table
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide 209
U1-18 oPE Fault Parameter Displays the parameter number that caused the oPE02 or oPE08 (Operation error).
No signal output
available
–
U1-19
MEMOBUS/Modbus
Error Code
Displays the contents of a MEMOBUS/Modbus error.
No signal output
available
–
U1-25
Software Number
(Flash)
FLASH ID
No signal output
available
–
U1-26 Software No. (ROM) ROM ID
No signal output
available
–
<9> Values shown here are for 200 V class drives. Double the value when using a 400 V class drive. Multiply value by 2.875 for 600 V class drives.
<10> The display resolution depends on the rated output power of the drive. Models CIMR-LU20008 to 20033, 40005 to 40018, and
50003 to 50013 display values in 0.01 A units, while models CIMR-LU20047 to 20415, 40024 to 40605, and 50017 to 50200
display values in 0.1 A units.
<12> The display resolution depends on the rated output power of the drive. Models CIMR-LU20008 to 20033, 40005 to 40018, and
50003 to 50013 display values in 0.01 kW units, while models CIMR-LU20047 to 20415, 40024 to 40605, and 50017 to
50200 display values in 0.1 kW units.
<29> Setting units are determined by the digital operator display unit selection (o1-03). When o1-03 = 0, the value is set in Hertz. When o1-03 = 4 or
5, the value is displayed in m/s. When o1-03 = 6, the value is displayed in ft/min.
<40> When checking the values of U1-03, U2-05 and U4-13 with the digital operator they are displayed in units of amperes, but when they are
checked using MEMOBUS communications, the monitor value in MEMOBUS communications is: displayed numeric value / 8192 × dr
ive’s
rated
current (A), from the condition “8192 (maximum value) = drive’s rated current (A)”.
No. Name Description
Analog Output
Level
Unit
U1
-
19=00000000
CRC Error
Data Length Error
Not Used
Parity Error
Overrun Error
Framing Error
Timed Out
Not Used
1
1
0
1
1
1
1
0
TOEP_C710616_38H_7_0.book 209 ページ ２０１５年１１月１１日 水曜日 午後７時４０分
To Next Page
Loading...
