2 Display and Operations of Panel Screen
FS100 2.1 Interface Panel Display
2-3
HW1480724
HW1480724
2.1.3 Panel Screen Operation by PP Keys
Follow the operations as below to perform ON/OFF operation on the panel
screen by PP keys.
1. Use the arrow key to move to the place where ON/OFF operation is to
be performed.
2. Hold down [INTERLOCK] and press [SELECT].
SUPPLE
-MENT
Set the item “INTERLOCK ENABLE” in the I/F PANEL
SETUP screen to “PERMIT”, and operations are allowed
without pressing the [INTERLOCK] key.
See the item No.8 “Interlock Enable” in the table “Data of
Each Setting Items” of chapter 3.2 “Details on Interface
Panel Setting Items” at page 3-12.
SUPPLE
-MENT
Set the following parameter to “1” to allow operations only by
the Touch panel (prohibiting the operations by cursor key).
Parameter: S2C399 (IF panel operation by cursor key)
0: Enable, 1: Disable
To Next Page
Loading...
