6 Parameters
FS100 6.1 Clearing the Status of Signals
6-2
HW1480724
HW1480724
6.1.1 Status of General Output Signals at Mode Change
By setting parameters from S4C064 to S4C071, it allows to set the status
of general output signals (#10010 to #11287) at the time of when changing
mode.
For the parameter settings, refer to the table below.
6.1.2 Status of General Output Signals at Power Supply ON
By setting parameter S2C235, it allows to set the status of general output
signals (#10010 to #11287) at the time of when turning the power supply
ON.
For the parameter setting, refer to the table below.
Parameters General Output
Signals
Set Values Explanation
S4C064 #10010
to #10167 (Bit
specification)
0: Hold,
1: Clear
When a bit specification is
set to "1", the status of
general output signals will
be cleared at the time of
changing mode.
(Bit specification is to be set
by a series of 8 signals.)
S4C065 #10170
to #10327
S4C066 #10330
to #10487
S4C067 #10490
to #10647
S4C068 #10650
to #10807
S4C069 #10810
to #10967
S4C070 #10970
to #11127
S4C071 #11130
to #11287
Parameters General Output
Signals
Set Values Explanation
S2C235 #10010
to #11287 0: Hold,
1: Clear
When S2C235 is set to "1",
the status of general output
signals will be cleared at the
time of power supply ON.
(All signals are to be set
together.)
To Next Page
Loading...
