3 Data Setting and Touch Panel I/F Instructions
FS100 3.1 Setting Procedure
3-4
HW1480724
HW1480724
3.1.2 Editing of Setup
1. Move the cursor to the item "SETUP" in the I/F panel setting screen
and press [SELECT].
– The status of "SETUP" switches between "VALID" and "INVALID"
with each pressing of [SELECT].
– If the items "INPUT (DISP)" and "OUTPUT (SETUP)" in the I/F
panel setting screen are not set, the status of "SETUP" cannot be
set to "VALID".(See the No.2 "SETUP" in the table "Data of Each
Setting Items" of chapter 3.2 “Details on Interface Panel Setting
Items” at page 3-12.)
3.1.3 Editing of Panel Type
1. Move the cursor to the item "PANEL TYPE" in the I/F panel setting
screen and press [SELECT].
– The list of panel types is displayed.
2. Move the cursor to the panel type to be selected and press [SELECT].
To Next Page
Loading...
