vi
HW1483854
HW1483854
• Do not touch the inside of the panel for 5 minutes after the power is
turned OFF.
The remaining charged voltage in the capacitor may cause an electric
shock or an injury.
• Be sure to close the door and install the protection cover while the
power is turned ON.
Failure to observe this warning may result in a fire or an electric shock.
• Perform the following inspection procedures prior to conducting
manipulator teaching. If problems are found, repair them
immediately, and be sure that all other necessary processing has
been performed.
– Check for problems in manipulator movement.
– Check for damage to insulation and sheathing of external wires.
• Always return the programming pendant to the hook on the cabinet
of the YRC1000 after use.
If the programming pendant is left unattended on the manipulator, on a
fixture, or on the floor, the Enable Switch may be activated due to
surface irregularities of where it is left, and the servo power may be
turned ON. In addition, in case the operation of the manipulator starts,
the manipulator or the tool may hit the programming pendant left
unattended, which may result in personal injury and/or equipment
damage.
• The wiring and mounting must be performed by authorized and
qualified personnel.
Failure to observe this caution may result in fire or electric shock.
To Next Page
Loading...
Need help?
General
