5.2 Specifications and Ratings: Small Capacity
5.2.1 Specifications
5-4
*4. The given values are for when the Servomotor shaft is mounted horizontally and shock or vibration is applied in
the directions shown in the following figures.
The strength of the vibration that the Servomotor can withstand depends on the application. Check the vibration
acceleration rate.
*5. Use derated values for this combination. Refer to the following section for information on derating values.
5.2.2 Ratings on page 5-5
Side to side
Front to back
Vertical
Shock Applied to the Servomotor Vibration Applied to the Servomotor
Vertical
To Next Page
Loading...
