Installation and Operation Guide SOLECTRIA XGI 1500 (Rev A, April 2019)
13 of 77
Use Figure 3-3 to space strut channels for mounting. The holes on the bottom use the center as the reference
point and the hook at the top uses the top of the upper strut channel as its reference point. Use two 8 mm (
5
/
16
in) bolts (not provided) to connect the bottom brackets to the strut channel.
Figure 3-3 Mounting Holes – Rear View
Attach the inverter, with its mounting brackets in place, to the strut channel as shown in Figure 3-54. The top
brackets fit over the upper strut bar to hang the inverter while securing the upper and lower brackets to the
strut channel. The brackets are attached to the inverter in the factory.
Figure 3-4 Mounting the Inverter to the Strut Channels
32.625 in
28.625 in
To Next Page
Loading...
