8 Operation
8.7.6 Multiturn Limit Disagreement Alarm (A.CC0)
8-34
3. Change the setting to the desired number of revolutions.
4. To s ave t h e s e t t i ngs, c l ick Writing into the Servopack, and a warning message appears.
5. Click OK and the settings are changed to the new ones.
6. After turning off the power, restart the Σ-V-SD driver. Because only the settings for the Σ-V-SD
driver were made, the settings for the motor are still incomplete and Multiturn Limit
Disagreement alarm (A.CC0) occurs.
To Next Page
Loading...
