YASKAWA V1000 Series - User Manual

YASKAWA AC Drive V1000
IP66 Type
MANUAL NO. TOMP_C710606_75A
Type: CIMR-VCH-00
Models:
200 V Class, Single-Phase Input: 0.1 to 3.0 kW
400 V Class, Three-Phase Input: 0.2 to 18.5 kW
Kurzanleitung
Quick-Start-Guide
Guide de démarrage rapide
Manuale di avvio rapido
Guía de referencia rápida
TOMP_C710606_75A_0_0_prePrint.pdf 1 21.12.2010 13:52:13

YASKAWA V1000 Series Specifications

General

Model	V1000 Series
Series	V1000
Output Frequency	0.1 to 400 Hz
Overload Capacity	150% for 60 seconds
Type	AC Drive
Control Method	V/f Control
Input Voltage	200-240V, 380-480V
Output Voltage	0 to Input Voltage
Power Range	0.1 to 18.5 kW
Horsepower	0.2 to 25 HP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault
Communication Interfaces	Modbus RTU
Enclosure	IP20
Ambient Temperature	-10 to +50°C
Storage Temperature	-20 to +60°C
Humidity	5 to 95% RH (non-condensing)
Cooling Method	Fan Cooled

Summary

General Information and Safety Instructions

General Warnings

Provides essential safety warnings and conventions for using the drive.

Safety Warnings

Highlights critical safety warnings, including electrical shock and hazard identification.

WARNING

Important warnings about handling the drive, including electrical hazards and sudden movement.

Mechanical Installation

Wiring Instructions

Provides critical warnings and steps for removing the front cover and wiring the drive.

Main Circuit and Control Circuit Wiring

Explains how to route cables through glands and connect power and control circuits.

Main Circuit Wiring

Details wire gauge, fuse recommendations, and tightening torques for main circuit connections.

Control Circuit Wiring

Specifies wire gauge, cable glands, and tightening torques for control circuit wiring.

Electrical Installation

Main and Control Circuit Wiring

Illustrates and explains the main and control circuit wiring diagrams for the drive.

Wiring Specification

Details fuse, wire gauge, and terminal size specifications for main circuit wiring.

Tightening Torque Values

Lists specific torque values for tightening main circuit terminals.

Control Circuit

Describes screwless terminals for control circuits and recommended wire types.

Wiring the Main Circuit Input

Precautions and recommendations for wiring the main circuit input of the drive.

Wiring the Main Circuit Output

Important precautions to consider when wiring the main circuit output of the drive.

Ground Connection

Guidelines and requirements for proper grounding of the drive to ensure safety and performance.

Control Circuit Wiring Precautions

Precautions for wiring control circuits, including separation, cable types, and operator connections.

Keypad Operation

LED Operator and Keys

Introduces the LED operator and keys, explaining their role in programming and status indication.

Keys and Functions

Start Up

Drive Setup Procedure

Outlines the basic step-by-step procedure for setting up and starting the drive.

Control Mode Selection (A1-02)

Auto-Tuning (T1-0)

Details the Auto-Tuning function for automatically setting motor parameters and its different modes.

Frequency Reference and Acceleration; Deceleration Times

Run Command Source (b1-02)

Test Run

Parameter Table

Motor Data

Troubleshooting

General Fault and Alarms

Lists common faults and alarms, their causes, and corrective actions for drive troubleshooting.

Operator Programming Errors

Explains operator programming errors (OPE) and how to identify and correct them.

Auto-Tuning Errors

Lists potential errors encountered during Auto-Tuning and their corrective actions.