YASKAWA yasnac lx3 - Page 100

APPENDIX1 LIST OF ALARMCODE(Cent’ d)
Commandvalues for addresses B, X(U), Z(W)
specifying second straight line are determined
as follows, and programmed shape cannot be
formed.
Commandvalue for B
—
.A.
– 36IO.000, – 180.000 Address X(U) commanded
O, 180000 360000 for specifying second
–270.000, –90.000
Address Z(W) commanded
90.000, 270.000
for specifying second
straight line.
Commandvalues for addresses C and D for bev-
eling too large for the programmed shape.
(lfl-
eration cannot be made according to the command.
END -
>’
...............
‘,
POINT
\
“.
~;.START
c-
>
POINT
Commandvalues for address P and Q specifyi
ng radius for rounding too large for the pro-
grammed shape.
Operation cannot be made
according to the command.
No intersecting point for first straight line
and second straight line.
‘=Q;:NT
;:!!;\
First straight line and second straight line
on the same line.
ALARM‘145*
“X(U) or Z(W) not commanded.
●X(U) and Z(W) both commanded.
● R not commanded. Or “O” ‘ “ “ n
● I and K not commanded.
“O” commanded for I and
●P and C both commanded.
●Q and D both commanded.
commanaea ror K,
K.
ALARtl“146”
Beveling for commandC cannot be made.
G;
L’-
Beveling for commandD cannot be made.
CENTEROF -
;;~CULAR K
Q @y
POINT
No intersecting point between circular arc and
straight line.
–94–