YASKAWA yasnac lx3 - Page 99

SUPPLEMENTALALARMCODE
ALARM“095”
X-coordinates differnt between G71 command
cutting start point and last block for
finished shape program.
Z-coordinates different between G72 command
cutting start point and last block for finish-
ed shape program.
Z-coordinate for cutting start point by G71
commanddifferent from Z-coordinate for the
first block of the finished shape program.
(CommandG71 . . .
R1 is excepted. )
X-coordinate for cutting start point by G72
commanddifferent from X-coordinate for the
first block of the finished shape program,
(CommandG72
X-coordinate
G71 . . . R1.
point.
.
. . .
R1 is excepted. )
for finished shape program by
Commandexceeding cutting start
A
CUTTING
------ ----- ........--------------
~ START
L/ ~pOINT
Z-coordinate for finished shape program by
G72 . . .
R1 commandexceeding cutting start
point.
fi CUTTING
~ ! START
< ~POINT
ALARM‘140”
●Commandingone or no address of addresses B,
X(U), Z(W) specifying second straight line.
●Commandingtwo addresses of addresses B,
X(U), Z(W) specifying second straight line.
In addition to this, one or no address com-
manded among addresses A, I, K, specifying
first straight line.
“Address D specifying second beveling and ad-
dress Q specifying second rounding commanded.
“Commanding addresses X and Z specifying sec-
ond straight line and Q and D specifying
second beveling and rounding.
ALARM“143”
Commandvalues for addresses A, I, K specify-
ing first straight are determined as follows,
and programmed shape cannot be formed.
CommandValue for A
–360.000, –180.000,
0, 180.000, 360.000
-270.000, –90.000,
90.000, 270.000
Address I commandedfor
specifying first
straight line.
Address K commandedfor
specifying first
straight line.
–93–