YASKAWA yasnac lx3 - Page 113

El
-
1#6181
TGICNT
D
#6182
TG2CNT
$
$
n
#6198
TG8CNT
m
#6199
TG19CNT
TGICNTto TG19CNT:
No. of times used and operating times are in-
dicated individually for tools in groups 1 to
19.
Note: Writing is not permitted in this setting.
n
#6202
G71OFL
G71OFL:
Sets retraction value after completion of each
cutting cycle in Stock Removal in Turning (G71).
Set t ing range: O –65536
Setting: Least input increment
n’
#6203
G720FL
G720FL:
Sets retraction value after completion of each
cutting cycle in Stock Removal in Facing (G72).
Set t ing range: O –65536
Setting: Least input increment
n
#6204
G740FL
G740FL:
Sets retraction value (8) in Peck Drilling in
Z-axis (G74).
Setting range: O –65536
Setting:
least input increment
m
#6205
G750FL
G750FL:
Sets retraction value (d) in Grooving in
X-axis (G75).
Setting range: O –65536
Setting: Least input increment
a
#6206 G760FL
G760FL:
Sets cut depth (in X-axis) “a” in Automatic
Threadcutt ing (G76).
Setting range: O –65536
Setting: Least input increment
a
#6207
TINON
When the tape without program no. is stored,
program no. is set for the tape.
n
#6219 SNSW
Setting: O, 1, or40f system No. switch
● n
o:
SYSTEM
For usual operation. Writing parameters is
prevented.
Ss
1:
PARAMETER
To write parameters. At this position, the
Cycle Start is prevented.
–lo7–