YASKAWA yasnac lx3 - Page 50

4.3,17 TAPEMODEDOESNOTFUNCTION
Trouble
Failure of input signa
Mcldeinput(T) is not
correct.
TAPEmode does not
s tart.
..— —
Parameters failures
such as baud rate, sto
bit and control code
Tape reader setting
failure
C13nnection failure
Failure of tape reader
Others
Check Procedure
mM1300D.i should bel, but
#1300 Do to D, and DS to D?
should be O.
TAPEshould appear on PRGscreen,
Refer to Par. 4.3.9
Refer to Par. 4.3.14, “RS232CDoes Not
Function Well”.
Tape Reader Setting
DIP Wtch (OS)
J I I I
For
For
Input
Tm.nsa13-
Cuitml
I
For
Read Tram.is-
NJlu
Pm
sOlf -
- sion
sOll-
lrwt
SeIw-
SFe=d :;: ,:_
Cnezkiq (cAar/s) Ewd rata Checking
COstrol
* standard setting
—
.
.
.
.
Dip switch arrangement) -- standard setting
0
0
UFF ‘L-T–
[[ 1
~ :T:.’2C!::1
ON
_l#L :. :
Check the wiring status of RS232C
cable according to the Connecting
Manual.
Check for looseness of connector.
Tape does not work even by depressing
tape feed switch.
Tape reader LED(red) does not light.
1 f)ower is not applied to the tape
reader.
2 Failure of tape reader,
Check tape retainer again.
Solution
Check setting status of
tape reader Model 2801B-2
according to the table at
the left column and set it
correctly again.
Correct connection.
Plug in firmly if loose.
Replace the tape reader.
Failure of MI120or cable
Replace the tape reader.
–44–