User Guide for the SIP-T19(P) E2 IP Phone
100
Intercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call
while there is already an active call on the phone. If Intercom Barge is enabled, the
phone will automatically answer the intercom call and place the active call on hold. If
Intercom Barge is disabled, the phone will handle an incoming intercom call like a
waiting call. Intercom Barge is disabled by default.
To configure intercom features via phone user interface:
1. Press Menu->Features->Intercom.
2. Make the desired changes.
3. Press the Save soft key to accept the change or the Back soft key to cancel.
These specific parameters are configurable via web user interface at the path
Features->Intercom.
You can use multicast paging to quickly and easily broadcast time sensitive
announcements to users who are listening to a specific multicast group. You can
configure a paging list key on the phone, which allows you to send a Real Time
Transport Protocol (RTP) stream to the pre-configured multicast address(es) without
involving SIP signaling. You can configure the phone to receive an RTP stream from
pre-configured multicast listening address(es) without involving SIP signaling. You can
specify up to 10 multicast listening addresses.
To configure a paging list key via web user interface:
1. Click on DSSKey->Programable Key.
2. Select the desired programable key.
To Next Page
Loading...
Need help?
General