Customizing Your Phone
47
The default value is 10, you can set to 1-30.
5. Click Confirm to accept the change.
Backlight
Backlight has three options:
Active Level: The intensity of the LCD screen when the phone is active. You can change the
intensity of the LCD screen. Digits (1-10) represent different intensities. 10 is the highest
intensity.
Inactive Level: The intensity of the LCD screen when the phone is inactive. You can select a low
intensity or turn off the backlight.
Backlight Time: The delay time to change the intensity of the LCD screen when the phone is
inactive. You can select a desired time to change the intensity or turn on the backlight
permanently.
Always On: Backlight is on permanently.
15s, 30s, 1min, 2min, 5min, 10min or 30min: Backlight is changed when the phone is
inactive after the designated time (in seconds).
You can also change the intensity of the LCD screen of EXP40 connected to the SIP-T46G IP
phone.
To configure the backlight via phone user interface:
1. Press Menu->Basic->Display->Backlight.
2. Press or , or the Switch soft key to select the desired value from the Active Level
field.
3. Press or , or the Switch soft key to select the desired value from the Inactive
To Next Page
Loading...
