Yealink W52P - Page 15

Getting Started
3
 Ethernet Cable
 Belt Clip
 Quick Start Guide
Check the package before installation. If you find anything missing, contact your system
administrator.
You have two options for power and network connection of the base station. Your
system administrator will advise you which one to use.
 AC power (Optional)
 Power over Ethernet (PoE)
Note
AC Power (Optional)
To connect the AC power:
1. Connect the DC plug on the power adapter to the DC5V port on the base station
and connect the other end of the power adapter into an electrical power outlet.
2. Connect the supplied Ethernet cable between the Internet port on the base station
Please pay attention to the radio coverage of the base station. It is up to 300m in
unobstructed outdoor areas and up to 50m inside buildings.
Set up the base station and the charger cradle at a central location on a flat, non-slip
surface in your house or apartment.