Yealink W52P - Page 66

Yealink W52P IP DECT Phones Configuring Guide
54
 Beep On: Auto intercom feature is on. The handset will answer an incoming internal
intercom call automatically and play a warning tone.
 Beep Off: Auto intercom feature is on. The handset will answer an incoming internal
intercom call automatically without a warning tone.
 Off: Auto intercom feature is off. You need to answer an incoming internal intercom
call by pressing the Accept soft key.
To configure auto intercom via CommPortal phone configurator:
1. Click on Features->Intercom.
2. Select the desired value from the Intercom Auto Answer pull-down list.
3. Click Save changes to accept the change.
4. Perform auto provisioning on the phone to download above configurations. For
more information on how to perform auto provisioning, refer to Downloading
Configuration Files on page 17.
You can configure the channel mode when an incoming intercom call is answered through
the handset. Make sure the Intercom Auto Answer feature is enabled in advance.
To configure headset mode via CommPortal phone configurator:
1. Click on Features->Intercom.