NeoGate TG Series User Manual
http://www.yeastar.com 24/56
5.3.4 Email settings
To send the SMS or system alert to email address, please configure the Email settings first,
and make sure SMTP test is successful.
Figure 5-21
The E-mail Address that NeoGate TG will use to
send voicemail.
The password for the email address used above
The IP address or hostname of an SMTP server that
the NeoGate TG will connect to in order to send
voicemail messages via email, i.e.
mail.yourcompany.com.
SMTP Port: the default value is 25.
Use SSL/TLS to send
secure message to server
If the server of sending email needs to
authenticate the sender, you need to enable this
Note: Must be selected for Gmail or exchange
server.
After filling out the above information, you can click on the “Test Account Settings” button
to check whether the setup is OK.
1) If the test is successful, you can use the email safely.
2) If test failed, please check if the above information is correct or network is proper.
5.3.5 Firmware Update
Upgrading of the firmware is possible through the Administrator Web interface using a
TFTP Server or an HTTP URL.
Enter your TFTP Server IP address and firmware file location, then click start to update the
firmware
To Next Page
Loading...
Need help?
General
