Yeastar Technology NeoGate User Manual

NeoGate TG Series User Manual
http://www.yeastar.com 47/56
Items
Description
From Field
Where to get the caller ID in SIP packet
To Field
Where to get the DID in SIP packet
180 Ringing
It is set when the telecom provider needs.
Usually it is not needed
Remote Party ID
Whether send Remote-Party-ID on SIP header.
Default no.
Allow Guest
Whether allow anonymous registration
extension. Default: no. It’s recommended to be
disabled for security.
Pedantic
Enable pedantic parameter. Default: no.
Alwaysauthreject
If enabled, when NeoGate TG rejects “Register”
or “Invite” packets, NeoGate TG always
respond the packets using “SIP404 NOT
FOUND”. It’s recommended to be enabled for
security.
Session -timers
Enable session-timer mode, default: yes. If you
found the call is cut off every 15 minutes every
time, please disable this.
Session-expires
The max refresh interval
·Session-minse
The min refresh interval, which mustn't be
shorter than 90s
Session-refresher
Choose session-refresher, the default is Uas
7.2.4 IAX Settings
IAX is the Internal Asterisk Exchange protocol, you can connect to NeoGate TG or register
IAX trunk to another IAX server. It’s supported by the asterisk-based IPPBX.
Figure 7-26
Items
Description
Bind Port
Port used for IAX2 registrations. Default is 4569.
Bandwidth
Low/medium/high with this option you can control
which codec to be used.

Yeastar Technology NeoGate Specifications

General

Brand	Yeastar Technology
Model	NeoGate
Category	Gateway
Language	English