To Next Page

To Previous Page

NeoGate TG Series User Manual

http://www.yeastar.com 53/56

Call Destination

Choose the destination trunk to route the call to

Hotline

When it’s configred, this number will be dial via

destination trunk permanently

Two stage Dial

Enable it to get the customized two stage dial tone

before dial out, it’s disabled by default.

Outbound Dial Pattern

Outbound calls that match this dial pattern will use

this outbound route. Hover the pointer over to

read tips.

Strip digits from front

before dialing

Allows the user to specify the number of digits that

will be stripped from the front of the phone number

before the call is placed.

Prepend these digits

before dialing

These digits will be prepended to the phone

number before the call is placed

7.3.3 Blacklist

Blacklist is used to block an incoming/outgoing call. If the number of incoming/outgoing

call is listed in the number blacklist, the caller will hear the following prompt: “The number

you have dialed is not in service. Please check the number and try again”. The system will

then disconnect the call.

Figure 7-34

We can add a number with the type: inbound, outbound or both.

7.3.4 Callback Settings

NeoGate TG allows caller A to dial an inbound route number, and after hearing the ring, A

can hang up the call or wait for NeoGate TG to cut off the call, then NeoGate TG will call A

with this number. When A picks up the call, A can dial the number he wants to call;

NeoGate TG will route this call to destination trunk.

Notes:

1. If you’d like to use callback feature, please make sure it’s enabled on the “Mobile to IP”

or “IP to Mobile” setting panel.

Yeastar Technology NeoGate User Manual

Questions and Answers: