TA410/810 User Manual
Figure 3-19 Common Rule
Table 3-9 Description of Common Rule Settings
A name for this rule, e.g. “HTTP”.
Simple description for this rule. E.g. Accept the specific host to access
the Web interface for configuration.
The protocols for this rule.
Initial port should be on the left and end port should be on the right. The
end port must be equal to or greater than start port.
IP
The IP address for this rule. The format of IP address is: IP/mask
E.g. 192.168.5.100/255.255.255.255 for IP 192.168.5.100
E.g. 192.168.5.0/255.255.255.0 for IP from 192.168.5.0 to
192.168.5.255 .
The format of MAC Address is XX:XX:XX:XX:XX:XX, X means 0~9 or
A~F in hex, the A~F are not case sensitive.
Accept: Accept the access from remote hosts.
Drop: Drop the access from remote hosts.
Ignore: Ignore the access.
Note: The MAC address will be changed when it’s a remote device, so it will not be
working to filter using MAC for remote devices.
3.2.6 IP Blacklist
You can set some packets accept speed rules here. When an IP address which hasn’t
been accepted in common rules sends packets faster than the allowed speed, it will
be set as ablack IP address and beblocked automatically.
27/55
To Next Page
Loading...
Need help?
General
