Yeastar Technology TA410 - 4.2.4 IAX Settings

TA410/810 User Manual
or “Invite” packets, TA410/81 always respond the
packets using
“SIP404 NOT FOUND”.It’s
recommended that it is enabled for security
reason.
Session-timers
Enable session-timer mode, default: yes. If you
find the call is cut off every 15 minutes every
time, please disable this.
Session-expires
The max refresh interval
Session-minse
The min refresh interval, which mustn't be
shorterthan 90s.
Session-refresher
Choose the session-refresher, the default is Uas.
4.2.4 IAX Settings
IAX is the Internal Asterisk Exchange protocol, you can connect to TA410/810 or
register IAX trunk to another IAX server. It’s supported by the asterisk-based IPPBX.
Figure 4-13 IAX Settings
Table 4-10 Description of IAX Settings
Items
Description
Bind Port
Port used for IAX2 registrations. The default is 4569.
Bandwidth
Low/medium/high with this option you can control which
codec to be used.
Min Registration Time
Minimum duration (in seconds) of an IAX2 registration.
Default is 60 seconds
Max Registration Time
Maximum duration (in seconds) of an IAX2 registration.
Default is 1200 seconds.
Codecs
Enable the codec you want for IAX communication.
46/55